Product ID:PREMIUM INTERIOR ALKYD SEMI-GLOSS PAINT, 63.040
MSDS Date:08/10/1992
FSC:8010
NIIN:00N066002
MSDS Number: BZMMM

WATTYL PAINT CORPORATION

5275 PEACHTREE INDUSTRIAL BLVD
ATLANTA, GA 30341
US

Emergency Phone: 404-455-7000

Info Phone: 404-455-7000

Cage: WATTL

WATTYL PAINT CORP

ATLANTA, GA 30341 US

Telephone: 404-455-7000

Cage: WATTL

2 MM HG

CAS: 8052-41-3

RTECS: WJ8925000

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9495

0.05 MM HG

OSHA PEL 100 PPM (MFR)

ACGIH TLV: 500 PPM (MFR)

OTHER PREC SECTION SHOULD BE CAREFULLY OBSERVED &

RTECS: 9999999ZZ

THE DRY COATING IS SANDED OR ABRADED IN SUCH A WAY AS

RTECS: 9999999ZZ

ANY TLV LISTED IN ING SECTION MAY BE EXCEEDED.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INHALATION: ANESTHETIC.
IRRITATION OF THE RESPIRATORY TRACT, OR ACUTE NERVOUS SYSTEM
DEPRESSION CHARACTERIZED BY THE FOLLOWING PROGRESSIVE STEPS:
HEADACHE, DIZZINESS, STAGGERING GAIT, CONFUSION, UNCONSCIOUSNESS
OR COMA. SKIN OR EYE CONTACT: PRIMARY IRRITATION. CHRONIC: MAY
CAUSE RESPIRATORY AND/OR(EFT OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: SKIN SENSITIZATION. PERMANENT CENTRAL
NERVOUS SYSTEM CHANGES DUE TO SOLVENT OVEREXPOSURE HAVE BEEN
REPORTED.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE FROM EXPOS. RESTORE BREATHING. TREAT
SYMPTOMATICALLY. CONSULT MD. EYES:FLUSH IMMED W/LRG AMTS OF H*2O
FOR AT LEAST 15 MIN. TAKE TO MD FOR MEDICAL TREATMENT. SKIN:WASH
AFFECTED AREAS OF SK IN W/SOAP & H*2O. REMOVE DRENCHED CLTHG.
CONSULT MD IF IRRIT PERSISTS. INGEST:DRINK ONE OR TWO GLASSES OF
H*2O TO DILUTE. DO NOT INDUCE VOMIT. CONSULT MD/POIS CTL CTR AT
ONCE. TREAT SYMPTOMATICALLY.

Flash Point:100F,38C
Lower Limits:1.0%
Extinguishing Media:USE NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
CLASS B EXTING/EXTINGUISHING AGENT DESIGNED TO EXTING FLAM LIQ
FIRES.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, ELEC EQUIP, SPARKS & OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. APPLICATN TO HOT (SUPDAT)

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION (FLAME, HOT
SURFACES, AND ELECTRICAL, STATIC OR FRICTIONAL SPARKS). AVOID
BREATHING VAPORS. VENTILATE AREA. CONTAIN AND REMOVE WITH INERT
ABSORBENT AND NON-SPARKING TOOL S.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES ONLY IN BUILDINGS DESIGNED TO COMPLY WITH OSHA 1910.106.
CLOSE CONTAINER AFTER EACH USE.
Other Precautions:DO NOT TAKE INTERNALLY. OBSERVE GOOD SANITARY
PRACTICES. NOTE:PIGMENTED PAINTS & COATING (THOSE WHICH ARE OPAQUE,
COLORED/WHICH HAVE REDUCED GLOSS WHEN DRY) MAY CNTN MATLS SUCH AS
SILICA, TALC, CALCIU M CARBONATE, TITANIUM DIOXIDE, (SUPDAT)

Respiratory Protection:IF SPRAYED IN AREAS W/UNRESTRICTED VENT, USE
NIOSH/MSHA APPRVD MECH FILTER TO REMOVE OVERSPRAY; IN RESTRICTED
AREAS USE APPRVD CHEM/MECH FILTER TO REMOVE BOTH PARTICLES & VAP.
FOR ANY METH OF APPLICAT ION IN CONFINED AREAS WHERE (ING 5)
Ventilation:PROVIDE SUFFICIENT VENT, IN VOLUME & PATTERN, TO INSURE VAP
CONC WELL BELOW ANY TLV & LEL LISTED IN ING SECTIONS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ:SURF REQ SPEC PREC. DURING EMER SITUATIONS OVER-EXPOS TO
DECOMP PROD MAY CAUSE HLTH HAZ. SYMP MAY NOT BE IMMED APPARENT.
OBTAIN MED ATTN. OTHER PREC:ETC, WHICH ARE HAZ TO INHALE IN DRY
POWDE R FORM. THESE HAZ ARE NOT BELIVED TO BEPRESENT WHEN POWDERS
ARE DISPERSED IN LIQ COATINGS. HOWEVER, PREC IN (ING 3)

Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.08-1.29
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:57-61

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:WHEN HEATED TO DECOMPOSITION, AS IN A
FIRE OR IN WELDING, MAY PRODUCE TOXIC FUMES SUCH AS CARBON
MONOXIDE.

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. INCINERATE IN APPROVED FACILITY. DO NOT
INCINERATE CLOSE CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.